KWC K99 Field Strip Guide*uploaded*, by HEATLoE

[Spetsnazgg]

Here is the guide that I made that shows the step-by-step disassembly of the KWC K99. If this in any shape or form breaks/destroys your gun, I'm not responsible.

How to:

-Lock the slide back
-Remove the magazine
-Pull the back tab down and off



Back tab on the back of the slide


-Release the slide
-Fire the weapon
-Punch out the front pin from the right side (I used a nail set the first time, it gets eaiser the more you do it)



Front pin that holds slide on


-Pull the slide foward and off the frame


Slide internals


-Hold the barrel assembly foward and push down through the ejection port


How to remove the cylinder


-Pull the cylinder assembly out through the back


The cylinder/piston/spring/and barrel


-Release the barrel assembly
-Push on the ejector port cover and pull out the barrel/recoil-guide and spring
-Pry off both rings
-Pull out the pin
-Slide barrel out


Cylinder apart


-Punch out both pins (I used a coat hanger tip)


Pins that hold in the trigger box


-Hold rear of trigger box and slide it out


Right side of the trigger box


Left side of the trigger box


Empty lower frame with magazine

Trigger box instructions:

-Lay the trigger box left side up
-Remove both screws
-Gently pull the halves apart (the piston sear will probably pop out when it comes apart)
Thats how you take it apart. Quite easy, it's just hard to get the piston sear seated properly. You can tinker with all the parts inside if you wish.


Right side of the trigger box


The trigger, same as stock, except this is metal


The trigger box opened


The proper position of the piston sear and spring


As far as I have gone

When I was taking it apart today to get the pics, I noticed a small crack on the rear of the trigger box that held the spring guide in place:



This is how my dad and I figured out how to fix it. We took a small drill bit and drilled down the side that was cracked. We took a screw that was slightly larger, took the head off with a die grinder, and pressed it in. That baby didn't move at all after.

The guide is pretty much complete now, anything else you want me to add, you can post below or any suggestions/questions. I have a huge pic of the parts layout (2.13mb 2592x1944) if anyone needs to see alot of detail on it I can send it to you.

This post has been edited by Shriak on Mar 13 2004, 11:24 AM

[Shriak]

Edited and ready for posting.

[Spetsnazgg]

Edited and uploaded on to website.

Go check it out at http://loairsoft.da.ru/

[HEATLoE]

I was just searching around Yahoo and found this. I remember you asking ages ago about putting this up. Glad to see you got it up and that it has helped atleast one person.


Nice site and forums.